Hello everyone,
I wante to ask because i really confused so many theories regarding CS2 and I'm so confused who to trust and what to trust.... My PC is amd 7 7800x3d, gpu 4070super and monitor BenQ XL2540 240 hertz(Monitor is compatible from Nvidia, was gsync before... on my monitor it activates as Freesync). What should i use with my PC(reflex,reflex+boost or no reflex),gsync,vsync?
I did CS2 benchmark 1920x1080 and I average 786.2 fps / P1=277.8
Reflex+Gsync+Vsync is the dev recommended setting for minimal input lag without tearing. Add boost if you can get 240fps without dips
You're getting 3 times the monitors refresh rate, you need none of these.
Gsync+ vsync + reflex is the way to go.
Reflex on or reflex on + boost: You must test it yourself, every pc is different. If you are using a x3D cpu then reflex is pretty good.
Reflex enabled without boost, disable vsync, and disable gsync, enable boost player contrast, disable ambient occlusion , HDR to quality and disable FidelityFX super res. You should be seamless after that
so i disable all of them, low latency mode from nvidia is needed? also do i cap fps?
Vexum above responded , i dont want any of that because my fps is rly high
Vexum responded , i dont want any of that because my fps is rly high
Vexum responded , i dont want any of that because my fps is rly high
Your fps is high but frame time I bet you is super inconsistent. Consistent frames > than high fps.
https://github.com/Ark0N/-CS2-Benchmark-Automation
Test with this and pick the setup you get best results with... If you have bad 1% lows that go under your screen refresh rate, I would consider the gsync+reflex+vsync.
This is some of the setups I tested on my pc, I would consider the gsync setup if I had gsync available 😜
You want the gsync sync reflex setup. Been playing for 15 years. It's the smoothest experience with zero tearing and consistent frame times.
can you help me set it up properly?